:O)
On Wed, 25 Jun 2003 14:04:37 -0700, "Glenn" <ggrrhh@no-spam>
wrote:
>Fight the Man! Right on comrade!
>
>Fill the first bank with any frequency but the bank must be full.
>
>Turn the radio off and disconnect all power internal and external. Leave it
>like this for at least 24 hours to drain any residual power in the scanner.
>Reconnect power while keeping the 6 key depressed and power on the radio.
>Start scanning the first bank, and first bank only. When the radio is
>scanning over the 6th channel press the 6 key and power off while keeping
>the 6 key depressed. If you do it at the correctly it will open up the
>"Federal" side of the radio. Your scanner will receive a programming tone
>from a local Federal repeater station and will go into AP mode,
>auto-programming. The display should be blank without power and stay blank
>until all the channels have been down loaded. This can take up to 6 hours
>depending upon where you live. When it is complete the display will use it's
>internal residual power to show three numbers repeated twice. The numbers
>displayed isn't important except any numbers will signal you were
>successful. Good luck and enjoy!
>
>
>
>
>"Shaun Hill" <Use-Author-Supplied-Address-Header@no-spam> wrote in message
>news:850a66e619f11be992c67321bd5b17d6@no-spam
>> I bought one of these and now i need a crack or ? so i can pickup the good
>> stuff so please fix me up cause i'd like to be one step ahead of Big
>> Brother.
>>
>> Blessings
>>
>
remove <SPAMSUCKS> to reply